Busbar processing machine cleaning

When the busbar processing machine is used for a long time, it will generate a lot of dust and product debris. If it is not cleaned in time, it may cause the normal operation of the machine. Therefore, for the bus processing machine, in addition to the maintenance work, the cleaning work is also The essential.
    First, the hot oil cleaning method Because the bearing used for a long time, soft dry oil or rust-proof paste hardened, should be immersed in the hot oil of 100-200 °C, clamp the bearing with pliers, use the brush to clean the oil on the bearing. The soft dry oil or rust preventive paste is heated to 100-200 ° C to melt, and is easily washed out from the gap of the bearing. Sometimes the bearing is shaken repeatedly in the oil. Oil stains will also flow away from the gap. When cleaning the centripetal spherical bearing of the old busbar processing machine motor or the imported motor, the ball, the bead frame and the inner ring should be laterally turned out from the outer ring and then immersed in the hot oil. When the short cylindrical roller bearing is cleaned, The roller, bead frame, inner ring and outer ring should be disengaged. When the hot oil is cleaned, the temperature of the oil should not exceed 20 °C. If you use an open flame to directly heat, you should pay attention to avoid burning the oil. The bearing should be hung in the oil pan, and the bottom will cause overheating and reduce the hardness.
    Second, the general cleaning method put the bearing in the fire oil for 5-10 minutes, pinch the inner ring with one hand, the outer ring of the other hand, the dry oil or anti-rust cream on the bearing will fall. Then put the busbar processing machine bearing into the cleaner oil, rinse it with a soft and soft brush, wash the oil in the ball and the gap, then put it in the gasoline for 1 time, take it out and put it on clean paper. . When the radial spherical ball bearing and the short cylindrical roller bearing are cleaned, the ball, the bead frame, the inner ring and the outer ring should be disconnected and cleaned. The cleaning of the bearing mounted on the shaft of the busbar processing machine is mainly based on the method of oiling or spraying with a grease gun. The oil that is simply cleaned is first used with petrol and then with gasoline; the oil that is difficult to clean is first used at 100-200 °C. Heat engine oil rinse or oil gun spray, then clean with gasoline. Be sure to pay attention not to scratch the bearing with sharp objects: hard grease or rust, to avoid damage to the smoothness of the bearing tumbling and groove ring parts, and the cleaned bearings are wiped dry with a clean cloth.
Therefore, I would like to remind everyone that when using the bus processing machine in the future, be sure to do his cleaning work from time to time.